Getting the Heat Right for Glass Tube Cutting If you’ve ever tried using a standard, off-the-shelf heater in an R&D lab, you know the...

Getting Your IR Heat Exactly Right: The Secret to Twin Tube Elements Most infrared lamps just blast a wide range of heat. For a lot of jobs, that’s...

Getting the Heat Right for Glass Tube Sealing If you’ve ever tried using a standard, off-the-shelf lamp in an R&D lab, you know the frustration....

Stop the Chipping: Why We Preheat Glass Cutting cold glass is basically a gamble. You score the surface, you apply pressure, and you just hope it...

Getting the Most Out of Your SWIR Heating Here is the thing about short wave infrared (SWIR) tubes: most people treat them like lightbulbs. They just...

Stop Burning Out Your IR Lamps Ever tried to move a piece of equipment across the ocean only to have it fry the moment you plug it in? It happens...

Getting Your Heat Exactly Right: The Truth About Twin Tube IR Elements If you’ve ever tried using a standard, off-the-shelf heating lamp for...

Stop Choosing Between Sharp Prints and Strong Glass Here’s the problem with silk-screening glass tubes: the ink acts like a shield. When you go to...

The Headache of Long-Haul Infrared Heating for Glass Kilns Most infrared lamps stop at 1.5 or 2 meters. That’s fine for a small setup, but if...

Stop Wasting Power on Your Glass Annealing Let’s be honest: glass annealing is usually a total energy hog. Most traditional resistive heaters...

On a tempering line or a lamination press, heat isn’t just a setting—it’s the constraint that sets the pace. When the heating module drags, the whole...